Choose 350-080 most accurate study material

Cisco 350-080 Exam Overview:

Cisco 350-080 Exam Syllabus Topics:

Cisco CCIE Data Center Written Sample Questions:

1. Refer to the exhibit.

What is the purpose of this command on the Cisco Nexus 7000 switch?

A) The command enables the FabricPath protocol on VLANs 1 through 10.
B) There is no need for this command because conversational learning is enabled by default for all VLANs.
C) The command enables conversational learning on FabricPath VLANs 1 through 10 for the F Series module.
D) The command enables conversational learning on a classic Ethernet VLAN for the F Series module.

2. Refer to the exhibit.

Which two statements about the exhibit are true? (Choose two.)

A) fc1/8 and fc1/9 on the MDS-A are configured as E Ports.
B) The domain ID for SAN A is 0x640.
C) fc1/8 and fc1/9 on the MDS-A are configured as F Ports.
D) The domain ID for SAN A is 0x64.
E) FC trunking is enabled on the Fabric Interconnect.
F) fc1/8 and fc1/9 on the MDS-A are configured as TE Ports.

3. Which statement about the SAN Extension Tuner is true?

A) Only SCSI read and write commands are implemented.
B) SET cannot be used if iSCSI is enabled.
C) The virtual N Ports that are created will register the FC4 features that are supported with the name server.
D) The data pattern that is used for the data that is generated between the virtual N Ports can be an all-zero pattern or an all-ones pattern. No other data patterns can be used.
E) The SET configuration is persistent across reboots.

4. Refer to the exhibit.

Which three statements about the exhibit are true? (Choose three.)

A) The Cisco Nexus 1000V Series uses a simple technique to prevent loops. Like a physical Ethernet switch, the Cisco Nexus 1000V Series Switch performs source and destination MAC address lookups to make forwarding decisions. The VEM applies loop-prevention logic to every incoming packet on Ethernet interfaces.
B) The Cisco Nexus 1000V Series uses a simple technique to prevent loops. Like any logical Ethernet switch, the Cisco Nexus 1000V Series Switch performs source and destination MAC address lookups to make forwarding decisions. The VEM applies loop-prevention logic to every incoming packet on Ethernet interfaces.
C) Because the Cisco Nexus 1000V Series does not participate in Spanning Tree Protocol, it does not respond to BPDU packets, nor does it generate them. BPDU packets that are received by Cisco Nexus 1000V Series Switches are dropped.
D) Because the Cisco Nexus 1000V Series participates in Spanning Tree Protocol, it responds to BPDU packets, and it generate them. BPDU packets that are received by Cisco Nexus 1000V Series Switches are dropped.
E) The differentiating characteristic of the Cisco Nexus 1000V Series is that it does not run Spanning Tree Protocol. This characteristic may seem to be a significant departure from other Ethernet switches, which might potentially cause catastrophic network loops. However, in reality, the Cisco Nexus 1000V Series implements a simple and effective loop-prevention strategy that does not require Spanning Tree Protocol.

5. Which three prerequisites must be met before configuring FabricPath on a Cisco Nexus 7000 switch? (Choose three.)

A) Ensure that you are working on the F Series module.
B) Ensure that you are working on the M Series module.
C) The FabricPath feature set must be installed only on the default VDC.
D) Spanning tree must be disabled on the switch.
E) The FabricPath feature set must be installed on the default and non-default VDCs.
F) Ensure that the Enhanced Layer 2 license is installed on the switch.

Solutions: